Impact of mechanical anisotropy on flat-rolled wires geometry - Mines Paris Accéder directement au contenu
Communication Dans Un Congrès International Journal of Material Forming Année : 2009

Impact of mechanical anisotropy on flat-rolled wires geometry


A precise final geometry of flat-rolled wires is required in view of their industrial applications. However, comparison between experimental and computed cross-sections shows a gap of 10%. This difference might originate in the anisotropy introduced by wire drawing. Coefficients of an anisotropic constitutive model (Hill 48) have been identified from transverse compression tests. Then Lam3®, a finite element software, has been used to simulate rolling passes. The anisotropic law previously established significantly improves the estimation of the final width: yet the underestimation of the experimental width is 5% instead of 10%. Possible ways for further improvement are discussed.


Fichier principal
Vignette du fichier
esaform2009_masse.pdf (353.77 Ko) Télécharger le fichier
Origine Fichiers produits par l'(les) auteur(s)

Dates et versions

hal-00509436 , version 1 (12-08-2010)



Thomas Massé, Yvan Chastel, Lionel Fourment, Pierre Montmitonnet, Christian Bobadilla, et al.. Impact of mechanical anisotropy on flat-rolled wires geometry. 12th ESAFORM Conference on Material Forming, Apr 2009, Enschede, Netherlands. pp.Pages 363-366, ⟨10.1007/s12289-009-0444-6⟩. ⟨hal-00509436⟩
156 Consultations
257 Téléchargements



Gmail Mastodon Facebook X LinkedIn More